Networking
RJ45 Network Cable Tester with Remote Unit
Check RJ45 and RJ11 cable continuity and wire order with a compact main tester and a detachable remote unit. Sequential LED indicators show the wiring order pin by pin, so a miswired pair is visible at a glance during assembly, installation and troubleshooting.
1 / 2 imagesFree shipping on orders of $59+
Ordering opens at launch
Leave your email and we'll write when you can order. Questions before then? .
- Shipping
- Standard shipping is a flat $5.99, and free on orders of $59 or more, to Puerto Rico, Washington DC and the contiguous United States. Shipping options and costs will be shown at checkout once ordering opens. Full shipping policy
- Returns
- You may request a return within 30 calendar days of your order's confirmed delivery date. Requesting a return does not automatically guarantee a refund. Full return policy
- Questions
- Contact support
What it does
Tests RJ45 and RJ11 cables
Main tester with a detachable remote unit for testing an installed run single-handed
Sequential LED indicators, positions 1–8 plus G
Stepping through the cable one conductor at a time
Continuity and wire-order checking
A break, a swap or a missing conductor shows as a skipped or out-of-sequence LED
OFF / ON / S
Selector, where S is the slow step rate
Overview
A terminated cable either works or it does not, and when it does not, the fault is almost always the order of eight wires you crimped a minute ago. This tester answers that question in seconds. Put the main unit on one end, the remote on the other, and watch the LEDs step through the pins.
The remote detaches from the main body, so a run already pulled through a wall or across a rack can be tested end to end by one person. Both halves carry RJ45 and RJ11 jacks, so patch leads and telephone cable are both covered by the same tool.
Good for
- Checking a patch lead straight after crimping it
- Tracing a dead wall port before blaming the switch
- Verifying an installed run from either end without a second person
- Keeping in a network install kit or a bench drawer
Specifications
specifications
- Connectors: RJ45 and RJ11 on both the main tester and the remote
- Indicators: 8 numbered LEDs plus a G position, on each unit
- Power: one 9 V battery
- Approximate size: 107 × 102 × 27 mm
Customer Reviews
No reviews yet.
Be the first to review this product.
